Bezel
Step 1.
Position the bezel on the front of the compute node.
Step 2.
Press the bezel securely against the chassis.
Note: Make sure that the bezel is pressed flat against the chassis around the power button, to
maintain access to the power button.
Removing the CMOS battery
Use this information to remove the CMOS battery.
Before you remove the CMOS battery, complete the following steps:
1. Read "Safety" on page iii and "Installation guidelines" on page 637.
2. If the compute node is installed in an Flex System chassis, remove it (see "Removing a compute node
from a chassis" on page 639 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the CMOS battery, complete the following steps:
Step 1.
Remove the cover (see "Removing the compute node cover" on page 643).
Step 2.
Locate the CMOS battery on the system board (see "System-board connectors" on page 17).
Step 3.
If a cover is over the CMOS battery, remove the cover.
Step 4.
Pivot the CMOS battery toward the left of the compute node.
Step 5.
Lift the CMOS battery from the socket.
650
Flex System x220 Compute Node Installation and Service Guide