Lenovo Flex System x220 Installation And Service Manual page 608

3. Replace the system board.
Related links
– "Updating firmware and device drivers" on page 21
– "Removing the system-board assembly" on page 683
– "Installing the system-board assembly" on page 684
• S.3070007 [S.3070007] A firmware fault has been detected in the UEFI image.
Explanation: Internal UEFI Firmware Fault Detected, System halted
Severity
Error
User Response
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
2. Update the UEFI image.
3. Replace the system board.
Related links
– "Updating firmware and device drivers" on page 21
– "Removing the system-board assembly" on page 683
– "Installing the system-board assembly" on page 684
• S.3108007 [S.3108007 ] The default system settings have been restored.
Explanation: System Configuration Restored to Defaults
Severity
Error
User Response
Complete the following steps:
Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
Related links
– "Updating firmware and device drivers" on page 21
• S.3818004 [S.3818004] The CRTM flash driver could not successfully flash the staging area. A
failure occurred.
Explanation: CRTM Update Failed
Severity
Error
600
Flex System x220 Compute Node Installation and Service Guide