Lenovo Flex System x220 Installation And Service Manual page 320

Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Temperature
SNMP Trap ID
0
CIM Information
Prefix: PLAT ID: 0522
User Response
Complete the following steps until the problem is solved: 1. Check the Chassis Management Module
or Flex System Manager event log for any fan- or cooling-related issues. 2. Make sure that the airflow
at the front and rear of the chassis is not obstructed and that fillers are in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
• 80070201-3104ffff : Sensor PCIE 4 Overtemp has transitioned to critical from a less severe state.
The temperature of the PCI expansion unit PCIe Card4 has exceeded its specified threshold.
May also be shown as 800702013104ffff or 0x800702013104ffff
Severity
Error
Serviceable
Yes
Automatically notify support
No
Alert Category
Critical - Temperature
SNMP Trap ID
0
CIM Information
Prefix: PLAT ID: 0522
User Response
Complete the following steps until the problem is solved: 1. Check the Chassis Management Module
or Flex System Manager event log for any fan- or cooling-related issues. 2. Make sure that the airflow
at the front and rear of the chassis is not obstructed and that fillers are in place and correctly installed.
3. Make sure that the room temperature is within operating specifications.
• 80070202-0701ffff : Sensor Planar Fault has gone to Critical state from a less severe state.
A failure has been detected in the system board.
312
Flex System x220 Compute Node Installation and Service Guide