DSA tape drive test results
The following messages can result when you run the tape drive test.
Test results for the DSA tape drive test
The following messages can result when you run the DSA tape drive test.
•
264-000-000 : Tape Test Passed
Tape Test Passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
–
IBM Support website
–
Latest level of DSA
–
Latest level of BMC/IMM
•
264-901-000 : Tape Test Failed
An error was found in the tape alert log.
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Clean the tape drive using the appropriate cleaning media and install new media.
2. Run the test again.
3. Clear the error log.
4. Run the test again.
5. Make sure that the drive firmware is at the latest level.
6. Rerun the test after upgrading to the latest firmware level.
7. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and
Service Guide" for the next corrective action.
.
Chapter 6
Troubleshooting
157