Drive Enables - Siemens Sinamics G120 Operating Instructions Manual

For example:
• A digital input can be made high without any wires in the terminals.
• An analog input or output can be driven to any value without any wires in the terminals.
• A digital output can be overridden and made high.
The screen presents the following options:
• I/O - Three I/Os can be simulated - two digital and one analog.
• Status - this indicates the real-time status of the input or output. If the square is shaded
• Control - this column of the screen displays the present status of the input or output and
To use the I/O simulation the following actions should be performed:
1. Using the wheel, rotate the wheel until the required digital input or output is displayed in
2. Press OK.
3. The relevant control field is highlighted.
4. Using the wheel, rotate the wheel until the required control signal is displayed.
5. Press OK.
6. Repeat this process until all the fields have been completed as required.
7. When all fields have been completed the "activate the simulation" will be highlighted.
8. Press OK. The simulation will start running.
9. While the simulation is running "Deactivate simulation" will be highlighted - Press OK to

Drive enables

The drive enables screen displays a list of all the current
enabling signals for the Inverter. If the enable signal is present
and active it will be selected
present and is not active it will be unselected ⃞.
This screen is read-only and is for information purposes only.
Intelligent Operator Panel (IOP)
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
then the input or output signal is present. This is a read-only section of the screen.
can be altered.
the first field.
stop the simulation.
. If the enable signal is not
Menu
6.2 Diagnostics
61