● All necessary equipment is available and installed correctly, according to the relevant
● All wiring of the Inverter, motor and any other devices used within the application has
● All components of the system have been tested to ensure their correct and safe
Information requested by the wizards
Since the IOP wizards will request detailed technical information during the setting-up
process, it is important to have this information available. This information can be obtained
from the following sources:
● Motor data - this data is obtained from the motor rating plate. See figure below.
● Sensor data - details of the types of sensors that may be used with the Inverter, such as
Boost
At low output frequencies, the V/f characteristics give only a low output voltage. This means
that the output voltage can be too low in order to:
● Implement the magnetization of an induction motor
● to hold the load
● to equalize losses in the system
● to provide a breakaway, acceleration or braking torque.
Intelligent Operator Panel (IOP)
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
wiring diagram for the specific application wizard.
been completed in accordance with the wiring diagrams included in the appropriate
section of this manual.
installation.
temperature sensors and pressure sensors. The required information is normally found
on the rating label of the sensor.
Figure 4-2
Typical motor rating plate
Wizards
23