Options
7.2 Hand-held device
Note
Battery lifetime
With the supplied rechargeable batteries in a fully-charged state they should last for
approximately 10 hours; the use of normal "AA" batteries may last considerably less time.
Industrial environment
The IOP has been designed for use within a Class A Industrial environment only.
Disposal of batteries
The batteries supplied with the IOP must be disposed of in accordance with local and
national environmental policies.
Battery status
The battery status is displayed at the top right-hand corner of the IOP display.
Battery charging
If the batteries are put on charge and the batteries are fully discharged; the charging unit will
enter a 'pre-charge' state. During the pre-charge state the LED will not be lit, therefore there
may be a delay before the charging LED lights up.
The IOP has no internal power source, so to increase the IOP's versatility, the hand-held
device has been designed.
Table 7- 1
Hand-held device order information
Order number
6SL3255-0AA00-4HA0
Note
Battery order information
The batteries supplied with the IOP Hand-held Kit should be replaced with exactly the same
type of batteries. The order and manufacturer information is given below.
Company:GP Batteries
Order Number:GP210AAH-C4
Website:http://www.gpbatteries.com/html/products/rechargeable_hydride.html
Datasheet:http://www.gpbatteries.com/pic/210aah.PDF
The layout of the IOP hand-held device is shown in the figure below.
98
Item quantity
Item
1
IOP
1
Hand-held module
1
Power supply unit
4
Rechargeable batteries
1
RS232 cable
Remarks
1.2 V NiMH (see note below)
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
Intelligent Operator Panel (IOP)