Siemens Sinamics G120 Operating Instructions Manual page 33

16. Select the Main Setpoint Source for the speed control of
17. Select the Additional Setpoint Source for the speed
18. Set the Minimum Speed at which the attached motor
19. Set the Ramp Up time in seconds.
20. Set the Ramp Down time in seconds.
Intelligent Operator Panel (IOP)
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
the Inverter/motor system.
control of the Inverter/motor system.
should run.
This is the time the Inverter/motor system will take from
being given the run command, to reaching the selected
motor speed.
This is the time the Inverter/motor system will take from
being given the OFF1 command, for the motor to reach
a standstill.
Wizards
4.1 Example wizard
33