Setpoint - Siemens Sinamics G120 Operating Instructions Manual

Control

Setpoint

The setpoint value determines the speed at which the motor runs as a percentage of its full
range of motion.
To change the setpoint, the following actions should be performed:
1. Rotate the Wheel to select "Control".
2. Press the Wheel to confirm selection.
3. The "Control" screen is displayed.
4. "Setpoint" is already highlighted.
5. Press the Wheel to select the "Setpoint".
6. The "Setpoint" screen is displayed.
7. Rotate the Wheel to increase or decrease the setpoint.
8. Press the Wheel to confirm new setpoint. If the "Esc" is
9. The "Control" screen is displayed.
10. Press "Esc" to return to the "Status" screen.
The setpoint can only be modified from the IOP when the
IOP is in Hand mode. Changing from HAND back to AUTO
will reset the setpoint.
54
given a single or a long press the setpoint is also saved.
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
Intelligent Operator Panel (IOP)