Chapter 2: Configuring System-Wide Settings
Describes how to configure various system-wide conference settings, how to configure
annunciator delay, dial delay, disconnect notification, wink timeout, and line fault settings, how
to set the system date and time, how to configure blast dial settings, and how to assign voice
messages and tones to conference events.
Introduction
System-wide settings specify most of the common operational attributes for conferences.
This chapter is organized as follows:
System Configuration
●
conference settings available from the System Configuration screen.
Table 7: System Configuration Parameters
●
parameters for annunciator delay, dial delay, line disconnect mode, and disconnect
notification mode settings available from the System Supervision screen.
System Date and Time
●
Blast Dial Parameters
●
Voice Message Configuration
●
voice messages, tones, or both in response to conference events.
Flex Configuration Settings
●
conference settings to implement Flex Conferencing.
System Configuration
To display or configure general system settings:
1. Select System Administrator Main > Configurations > System Configuration to display
the
System Configuration
on page 45 describes how to configure various system-wide
on page 68 describes how to set the system date and time.
on page 69 describes how to configure blast dial-out parameters.
on page 71 describes how to configure the system to play
on page 76 describes how to configure system-wide
dialog.
on page 47 describes how to configure
Issue 1 November 2008
45