Modifying Call Branding Entries
Use the cbutil update command to update an existing entry in the Call Branding table.
update <dnis> [-m <msg> -g <rg> -p <ps> -u <ucps> -f <func> -o <of>
-l <ln> -c <cn> -crs <n> -cre <n>] where:
where:
<dnis>
-m <msg>
-g <rg>
-p <ps>
-u <ucps>
-f <func>
-o <of>
-l <"ln">
-c <"cn">
-crs <n>
-cre <n>
Table 16: Call Branding Configuration Parameters
Tip:
The entry is not changed when you only specify
Tip:
Deleting Call Branding Entries
To delete Call Branding table entries use cbutil remove command to remove the entry from the
Call Branding table.
cbutil remove <"dnis">
where:
dnis
<"
">
Listing the Entries in the Call Branding Table
You can display a single entry or all entries in the call branding table.
DNIS
New annunciator message number
New Reservation Group
New Prompt Set number (0-20)
New Use Conference Prompt Set (y/n)
New Function: DIRECT/SCAN/ENTER/HANGUP/AUTOVL/FLEX
New On Failure function (optional): ENTER/HANGUP
New line name to associate with caller (optional)
New company name to associate with caller (optional)
New conference room start number (optional)
New conference room end number (optional)
is the DNIS for entry to remove.
Branding Calls using cbutil
on page 88 describes each parameter.
.
dnis
<"
">
Issue 1 November 2008
91