Configuring The Btoe Tcp Port; Figure 6-14: Popup Menu; Figure 6-15: About Ac Btoe; Figure 6-16: Tcp Port - AudioCodes 440HD User Manual


To make sure BToE is correctly installed:
1. Click the AC (AudioCodes) taskbar icon; the following menu pops up:
2. Select the About... menu option to verify the DLL and BToE version:
6.1.3

Configuring the BToE TCP Port

You can opt to configure a different BToE TCP port to the default 9999, depending on the
requirements of your enterprise. For example, you may decide to change the BToE TCP port to
5000 because your enterprise is using the default port of 9999, and 5000 is available. This
feature therefore provides enterprise administrators with more freedom in network administration.
Note: If you decide to change the default BToE TCP port, you must update both the PC and
the IP phone with the new BToE TCP port number.

To change the BToE TCP port on the PC side:
1. Click the AC (AudioCodes) taskbar icon; the menu shown in
2. Select Disconnect in the popup menu and then select Configuration > TCP Port.
3. From the AC BTOE TCP Port dialog that opens, configure the TCP Port:
User's Manual

Figure 6-14: Popup Menu

Figure 6-15: About AC BToE

Figure 6-16: TCP Port

78
430HD and 440HD IP Phone
Figure 6-14 pops up.
Document #: LTRT-11937