Configuring The Easytouch User Interface; Switching The Key Tone On/Off; Calibrating The Touchscreen; Adjusting The Touchscreen Brightness - Sirona Sinius CS Operating Instructions Manual

4 Operation
4.13 Configuration of the treatment center (setup)
158
4.13.2

Configuring the EasyTouch user interface

➢ Touch the
Configuring the EasyTouch user interface
 The sub-screen opens.

Switching the key tone on/off

4.13.2.1
Switching the key tone on/off
A setting can be made to activate or deactivate an acoustic signal that
sounds when the operator touches a key on the touchscreen or a fixed
key.
➢ Touch the
 If the key is highlighted orange, the key tone is activated.
4.13.2.2

Calibrating the touchscreen

Calibrating the touchscreen
If the touchscreen is no longer able to precisely locate the position of a
contact, it must be recalibrated.
1. Touch the
 A calibration field is displayed.
2. Touch the small cross on the touchscreen with a blunt pen.
 The cross is displayed at another location on the touchscreen.
3. Repeat this procedure until the cross no longer appears.
4. Touch the empty touchscreen again.
 The touchscreen is now calibrated. The
program is displayed again.

Adjusting the touchscreen brightness

4.13.2.3
➢ Use the – and + keys to set the brightness of the touchscreen.
Adjusting the touchscreen brightness
Operating Instructions SINIUS / SINIUS CS
EasyTouch user interface
Key tone
key.
touchscreen calibration
key.
Sirona Dental Systems GmbH
key in the setup program.
User interface
setup
63 22 726 D3561
D3561.201.01.03.02 05.2012