Setting Tally Enable - Sony CCP-8000 System Setup Manual

3-7. Tally Setup

3-7-4. Setting Tally Enable

Engineering Setup → Router/Tally → Tally Enable
Page 7364
This menu is used to set which Destination should be output to which tally.
In the video switching systems, there are many occasions that two or more independent jobs are carried
out by the same switching system.
For example, recording of the on-air program by VTR or by slow motion VTR while on-air is under way
or distributing the on-air program to the local network stations while on-air is under way is performed.
As the result, sophisticated tally system is required in order to correspond to the sophisticated output
system.
If a video switching system becomes sophisticated, the tally system that aims at attracting attention of
operators can become the cause of confusion on the other hand. In order to avoid this confusion, the entire
tally system can be divided into the two systems. After the entire tally system is divided into the two
systems, one tally system can be, for example, assigned to the on-air tally while the other tally system can
be assigned to the off-air live tally. The two colors of red and green can be used for the display of each
tally system.
Menu screen
3-29
MVS-8000 System
SYSTEM SETUP