3-7. Tally Setup
3-7-5. Setting Tally Copy
Engineering Setup → Router/Tally → Tally Copy
Page 7365
This menu is used to unify the tally information.
The virtual sources correspond to sources by one-to-one correspondence. However, there are cases that
the same source is connected to two or more input terminals at the same time.
For example, the ordinary video output signal and the video output signal with timecode from a single
unit of VTR are connected to the separate input terminals respectively.
Because the different tally informations that are searched separately can be created for a single unit of
equipment in such a case, these informations must be unified by obtaining the logical OR of the tally
informations corresponding to all virtual input terminals to which the equipments that have the two or
more outputs are connected.
For this purpose, unify the tally informations by this setting that is separate from the equipment connec-
tion information.
CAM1
CAM2
3-32
CAM3
VTR1
VTR2
Without
TC
Unifications
1 2 3 4 5 6
1
2
3
4
MVS
(switcher)
Menu screen
With TC
Monitor
On Air
VTR3
MVS-8000 System
SYSTEM SETUP