Lan Requirements - Sony CCP-8000 System Setup Manual

2-7. MVS-8000 System Control Cabling

2-7-2. LAN Requirements

The MVS-8000 system requires an Ethernet Local Area Network (LAN) for System Control LAN and
Data LAN.
Switcher Processor (MVS-8000), DME Processor (MKS-8800), and System Control Unit (MKS-8010)
are all connected via an Ethernet switch of appropriate specification.
Data LAN requires separate Ethernet switch from the one for Control LAN to avoid delay of the process-
ing.
m
. Ethernet Hubs are not acceptable for the MVS-8000 system Ethernet connection.
Use of hub instead of a switch may cause sluggish responses to panel button.
Connect each LAN (Control/Data) nodes to the different switch to avoid sluggish.
. Ethernet switches are not supplied with MVS-8000 system.
Ethernet specification
Refer to Table below for a list of required Ethernet Specifications for MVS-8000 system.
Ethernet specification
Cable Type
Connectors
Length
Switch Capacity of backbone
Throughput
Delay time of packet
Speed
Ports
VALN
Switching mode
Management
2-18
100 BASE-TX compatible.
RJ-45 male connector at each end of cable
100 m maximum
Higher than 1.5 Gbps
Higher than 120 Kbps (a port) packet size 64 Byte
Total throughput : higher than 3 Mbps
Less than 50u sec
Dual : 100 Mbps
RJ-45 auto negotiating 100 Mbps
Number of ports required is dependent upon system configuration
Compatible
Store-and-Forward
SNMP, RMON
MVS-8000 System
SYSTEM SETUP