Changing Ip Address - Sony CCP-8000 System Setup Manual

3-3. IP Address

3-3-2. Changing IP Address

The default IP address of the MVS-8000 system can be changed using dipswitch setting on CPU boards.
Device Board
MVS-8000 CA-44
MVE-8000 CA-44CF
CCP-8000 CA-45
DCU-8000 CA-47
Dipswitch on CPU board
Group ID
OPEN
CLOSE
1 2 3 4 5 6 7 8
1. Set the DIP switch on each device as you required.
See the bit of each switch (Group ID/Unit ID) in table.
Bit settings
Bit 1 2
Group ID 1 2
Unit ID 1 2
* : These bits are factory use only. Use the bits with the default setting (CLOSE) as shipped from the factory.
The Group ID and Unit ID switch setting determines all of the LAN IP addresses (Control/Data/Peripher-
al LAN).
The Peripheral LAN IP address is made by adding 64 to the Group ID.
The Data LAN IP address is made by adding 128 to the Group ID.
Switcher processor IP address
IP Address
10.2.2.1 (C)
10.130.2.1 (D)
10.5.2.2 (C)
10.133.2.2 (D)
10.10.2.10 (C)
10.138.2.10 (D)
C : Control LAN
D : Data LAN
3-4
Group ID
S102 (8bit)
S102 (8bit)
S902 (8bit)
S754 (8bit)
Unit ID
OPEN
CLOSE
1 2 3 4 5 6
3 4
4 8
4 8
Group ID
Group ID
1 2 3 4 5 6 7 8
Group ID
1 2 3 4 5 6 7 8
Group ID
1 2 3 4 5 6 7 8
Unit ID
S103 (8bit)
S103 (8bit)
S901 (8bit)
S755 (8bit)
7 8
5 6 7
16 32 Control
16 32 64
Unit ID
Unit ID
1 2 3 4 5 6 7 8
Unit ID
1 2 3 4 5 6 7 8
Unit ID
1 2 3 4 5 6 7 8
8
* *
Data
128
MVS-8000 System
SYSTEM SETUP