Sony CCP-8000 System Setup Manual page 89

Setting items
System 1
Tally Copy Setting is required
For the system 1 1 1 1 1
Set the virtual terminal number of copy source (From Source) and copy destination (To Source) as
required.
2 2
For the system 2 2 2
Because there is no equipment that is connected on matrix in this system, this setting is not necessary.
3 3 3
For the system 3 3
Set the virtual terminal number of copy source (From Source) and copy destination (To Source) as
required.
Setup example : For the system 3
System: MVS-8000 x 1 unit, router x 1 unit (8 x 4)
1. Connect the video signal (with TC) from VTR to Primary 8 (virtual terminal No. 26) of the switcher.
2. Connect the video signal (without TC) from VTR to Primary 7 (virtual terminal No. 25) of the
switcher.
Establish the Tally Copy setup because the tally information must be output after the tally informations
from the two sources are unified to a single tally information.
Page 7365
Copy# From Source
1 26
MVS-8000 System
SYSTEM SETUP
1 1 2 2
1 1 System 2 2 2
Setting is not required
3 3 3 3
To Source
SWR8 25
3 3
System 3 3 3
Setting is required
SWR7
3-7. Tally Setup
3-33