Sony CCP-8000 System Setup Manual page 62

3-4. Ethernet Switch Settings
A) Initialize ethernet switch
Cisco Catalyst 29xx-XL series or Cisco Catalyst 35xx-XL series require the following parameters to
initialize.
For details, refer to Quick Start Guide supplied with a Ethernet switch
n
If the following network configuration does not fit your existing Ethernet configuration, make sure all
nodes have unique node address and are place on the appropriate network.
IP address
Subnet mask
Default gateway
Host name
Secret password
Telnet password
Cluster command switch
*1 : On Second and later Ethernet switch, simply subtract 1 to the node address. For example, the second Ethernet switch would have
an address of 10.4.17.253.
*2 : On Second and later Ethernet switch, simply add 1 to the number of the host name. For example, the second Ethernet switch would
have a host name of CiscoSW2.
In case of Cisco Catalyst 4000 series or Cisco Catalyst 5000 series
Cisco Catalyst 4000 series or Cisco Catalyst 5000 series requires initializing and setting VLAN together.
Step the next procedure "B) Set VLAN".
3-6
10.4.17.254 *1
255.0.0.0
Not used
CiscoSW1 *2
ciscosw1 (host name in small letters)
ciscosw1 (same as secret password)
Not used
*2
*2
MVS-8000 System
SYSTEM SETUP