Sony CCP-8000 System Setup Manual page 44

2-5. DCU-8000 Installation
3. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
B4 x 10
3U
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step 2).
5. Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
Rack tool
Rail
6. Remove the front panel. (Refer to Section 1-4-1)
2-14
31.75
B4 x 10
31.75
Unit : mm
Rack tool
Rail
7. Fix the rack angle in the rack using the specified
screws.
Rack
Rack angle
B5 x 12
8. Attach the front panel to the equipment.
B5 x 12
Rack angle
MVS-8000 System
SYSTEM SETUP