Sony CCP-8000 System Setup Manual page 41

3. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
Rack
B4 x 10
3U
Adaptor
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step 2).
5. Align the groove of the rack tool at the side of the equip-
ment with the rail, and slide the equipment to the rear.
n
The rack tools are hooked on the rails as shown below.
Rack tool
Rail
6. Remove the front panel. (Refer to Section 2-1.)
MVS-8000 System
SYSTEM SETUP
Adaptor
31.75
Rack
B4 x 10
31.75
Unit : mm
Rack tool
Rail
7. Fix the rack angle in the rack using the specified
screws.
Rack
Rack angle
B5 x 12
8. Attach the front panel to the equipment.
2-4. CCP-8000 Installation
B5 x 12
Rack angle
2-11