Initializetag - Siemens RF182C Operating Instructions Manual

6.4.3

initializeTag

With this command the complete user memory area of the memory is deleted or overwritten
with a defined value.
Below the XML command for initializing tags (initializeTag) is described:
XML command
<command>
</command>
XML response
Below the XML response without error entry (for error entries, see section Error messages
(Page 71)) is described:
<reply>
</reply>
Parameter
Parameter
MemorySize
Value
RF182C communication module
Operating Instructions, 10/2010
<initializeTag>
<memorySize>MemorySize</memorySize>
<defaultValue>Value</defaultValue>
</initializeTag>
<resultCode>Errorcode</resultCode>
<initializeTag/>
Data type
ASCII hex
ASCII hex
6.4 Commands of the communication module
Values
0000 ... FFFF (4 x ASCII)
Memory size of the tag to be initialized
•
Note that this parameter depends on the tag. For
•
detailed information on the memory size, refer to the
respective MOBY System Manual or Appendix B
Addressing of the RFID tags (Page 123).
00 ... FF (2 x ASCII)
Hex value that is written to the tag.
•
Communication interface
55