Connecting - Siemens RF182C Operating Instructions Manual

Connecting

Proper use
When connecting non-specified devices to the RF182C, it is possible that the connected
device may be destroyed.
NOTICE
The device must not be connected to the public telephone network without a HUB / Switch
because the voltage intervals are designed for 500 V.
Ethernet setups
Ethernet communication can be established in BUS or STAR topology. Also note the
information in section Loop-through of Ethernet and supply voltage (Page 30).
PROFINET IO
Master module
SIMATIC S7
Figure 4-1 RF182C with BUS topology
RF182C communication module
Operating Instructions, 10/2010
4
21