Siemens RF182C Operating Instructions Manual page 51

Parameter
Parameter
Version
RF182C
Baud rate
LEDSuppression
Mode
Note
The baud rate and mode cannot be set individually; they apply for both channels.
RF182C communication module
Operating Instructions, 10/2010
Data type Values
ASCII 0 ... 9, A ... Z
Here you must enter the following version of the protocol as string:
V1.0
•
ASCII Here you must enter the following values:
RF182C
•
ASCII Here you must enter one of the following baud rates (in baud):
19200
•
57600
•
115200
•
ASCII Both channels, or channel 1 or channel 2 are flashing
NONE = run-up flashing is not suppressed by any of the two reader
•
terminals
TRANSM_POINT_1 = run-up flashing of the err_LED at the reader 1
•
terminal is being suppressed
TRANSM_POINT_2 = run-up flashing of the err_LED at the reader 2
•
terminal is being suppressed
ASCII U/D/RF300_DIRECT_ADDRESSING
Communication interface
6.2 Configuration parameters of the RF182C
51