Siemens RF182C Operating Instructions Manual page 17

2. Screw the connection block onto the base unit (torque 1 to 1.3 Nm) Tighten the screws
RF182C communication module
Operating Instructions, 10/2010
evenly, working in cross-wise passes. 4 screws are already located in the connection
block (see Figure).
Figure 3-2 Plug the connection block M12, 7/8'' onto the base unit and screw it on
Figure 3-3 Plug the push-pull connection block onto the base unit and screw it on
Note
IP65, IP66 or IP67 degree of protection only exists when the connection block is screwed
to the base unit.
3.3 Mounting the connection block
1
Mounting
17