Ghosting (4) - Xerox phaser 3140 Service Manual

Print-Quality Troubleshooting

Ghosting (4)

5-18
Downloaded From ManualsPrinter.com Manuals
There is ghosting at 75.3mm intervals. Fuser operating temperature is too high.
Initial Actions
• Ensure there is no debris in the Fuser.
• Verify the paper is within the printer specifications (refer to "Media and Tray
Specifications" on page 1-16).
Troubleshooting Reference Table
Applicable Parts
Fuser, PL9.0
Warning
Allow the Fuser to cool before starting the procedure.
Troubleshooting Procedure Table
Step Actions and Questions
1 Remove and disassemble the Fuser
(page 8-11). Remove contaminated
toner particles on the roller, and
clean any foreign matter between
the Thermistor and Heat Roller.
NOTE If the Heat Roller is deformed, replace
Does the problem persist?
Example Print
it (page 8-17).
Phaser 3140/3155/3160 Printer Service Manual
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Yes No
Replace the Complete.
Fuser
(page 8-11).