Iq9 Residual Image (Ghosting) Rap - Xerox Phaser 3052 Service Manual

IQ9 Residual Image (Ghosting) RAP

The image from a previous print appears on the current print
Procedure
Switch Off the Power.
Check the Transfer Roller for the following:
• Wear or damage.
• The left and right tension springs for damage.
• Be sure all parts are installed correctly.
The Transfer Roller is OK.
Y N
Replace the Transfer Roller or parts as needed;
If problem persists, Replace components in the following order:
• Print Cartridge, refer to the Xerox® Phaser® 3020 User Guide, Section 6 Maintenance,
General Care, for detailed instructions on how to replace the Print Cartridges.
• Fuser; (REP 1.14), PL 3.2.
• LVPS / HVPS PWB; (REP 1.5), PL
Figure 1 Ghost Image
Xerox® Phaser® 3020 Printer Service Manual
(Figure 1).
(REP 1.13), PL 3.1.
3.1.
IQ10 Blank Page RAP
The entire image area is blank (Figure
Initial Actions
Replace any components at end of life.
Procedure
• Switch Off the power.
• Check the space between the LSU and the Print Cartridge for a blockage, remove any
debris or blockage.
• Clean the contacts on the Print Cartridge and the LVPS / HVPS PWB.
• Switch on the power and make a test print.
The problem continues.
Y N
Go to Call Closeout.
Replace the Print Cartridge, refer to the Xerox® Phaser® 3020 User Guide, Section 6 Mainte-
nance, General Care, for detailed instructions on how to replace the Print Cartridges. The
problem continues.
Y N
Go to Call Closeout.
Check circuit between the Main PWB and the LVPS / HVPS PWB, BSD 1.1. The
OK.
Y N
Replace any defective components:
• Main PWB to LVPS / HVPS PWB Wire Harness.
• Main PWB; (REP 1.6),
• LVPS / HVPS PWB; (REP
Replace the LSU; (REP 1.10), PL
June 2014
3-9
1).
PL 1.1.
1.5), PL 3.1.
3.6.
circuit is
Image Quality
IQ9, IQ10