Error Messages and Codes
Toner Empty or Exhausted
3-20
Downloaded From ManualsPrinter.com Manuals
The Print Cartridge has reached the end of life count. When this error occurs the
red Error LED is On.
Initial Actions
•
Cycle printer power.
•
If problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Print Cartridge, PL1.0.12
Controller Board, PL 1.0.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Print the Configuration Report
(page 4-2), and check the Toner
Remaining count.
Is the cartridge at or near end of
life?
2
Reseat the Print Cartridge and cycle
printer power.
Does the error persist?
3
Reseat CN9 on the Controller Board
(CN10 on the 3160) and cycle
printer power.
Does the error persist?
4
Check for +3.3V at CN9-4 (CN10-4
on the 3160).
Is +3.3V present?
5
Replace the Print Cartridge
(page 8-6).
Does the error persist?
Wiring and Plug/Jack Map References
3140 Controller Board Wiring
3155 Controller Board Wiring
3160 Controller Board Wiring
Map 1 - Controller Board (3140)
Map 2 - Controller Board (3155)
Map 3 - Controller Board (3160B/
3160N)
Yes
Replace the
cartridge.
Go to step 3.
Go to step 4.
Go to step 5.
Replace the
Controller
Board
(page 8-51).
Phaser 3140/3155/3160 Printer Service Manual
No
Go to step 2.
Complete.
Complete.
Replace the
Controller
Board
(page 8-51).
Complete.