Print Speed; Warm-Up Time; Power Save Mode; First Print Output Time - Xerox phaser 3140 Service Manual

General Information

Print Speed

Warm-Up Time

Power Save Mode

First Print Output Time

Memory Specifications

1-12
Downloaded From ManualsPrinter.com Manuals
Media Phaser 3140 (ppm) Phaser 3155/3160 (ppm)
Letter 19
A4 18
Duplex Manual
Warm-up Time is defined as the time when the printer changes from Power-On to
Standby mode.
• From Power On (UI Ready): Less than 30 seconds
The default setting is 1 minute. Use the Printer Settings Utility or CentreWare IS to
change the default setting to 1, 5, 10, 15, 20, 30, 45, 60, or 120 minutes.
First Print Output Time (FPOT) is defined as the time from when the engine
receives a Start signal in Ready state, until a single page is printed and delivered to
the output tray.
Paper Size Phaser 3140
A4, A5, Letter Less than 10 seconds
Legal Less than 12 seconds
The following table lists FPOT when the printer is in Power Save mode.
Printer Mode Phaser 3140
Power Save Less than 30 seconds
Model
Phaser 3140, 3155
Phaser 3160
24
24
Manual
FPOT (sec.)
Phaser 3155, 3160
Less than 9 seconds
Less than 10 seconds
FPOT (sec.)
Phaser 3155, 3160
Less than 19 seconds
Memory
8 MB
64 MB
Phaser 3140/3155/3160 Printer Service Manual