Fuser Errors; Paper Rolled In The Fuser - Xerox phaser 3140 Service Manual

Fuser Errors

Paper Rolled in the Fuser

Phaser 3140/3155/3160 Printer Service Manual
Downloaded From ManualsPrinter.com Manuals
There are repeated media jams in the Fuser. When this error occurs the red Error
LED is On.
Warning
Allow the Fuser to cool before beginning the repair.
Initial Actions
• Check the media.
• Clean the Fuser's Pressure Roller and Heat Roller.
• Check the Fuser gear.
• If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL9.0
Drive Assembly, PL7.0 (3140)
Drive Assembly, PL7.1 (3155 and
3160)
Troubleshooting Procedure Table
Step Actions and Questions
1 Reseat the Fuser connections.
Does the error still occur?
2 Check the Fuser for contamination.
Is the Fuser dirty?
3 Check the guide claws for damage?
Are the guide claws damaged?
4 Replace the Fuser.
Does the problem persist?
Error Messages and Codes
Wiring and Plug/Jack Map References
Map 6 - Motor, Solenoids, and Fan
Yes No
Go to step 2. Complete.
Remove Go to step 3.
(page 8-11),
disassemble,
and clean the
Fuser.
If possible, Go to step 4.
repair the guide
claws.
Replace the Complete.
Drive Assembly
(page 8-35).
3-21