Error Messages and Codes
Fuser Gear Damaged from Overheating
3-22
Downloaded From ManualsPrinter.com Manuals
There is a repetitive jam at the Fuser, or the Fuser rollers are not turning.
Warning
Allow the Fuser to cool before beginning the procedure.
Initial Actions
•
Ensure that the Fuser is secured to the printer.
•
Cycle printer power.
•
If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser Lamp, PL9.0.13
Fuser, PL9.0
Power Supply, PL1.0.1
Controller Board, PL1.0.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the Fuser Lamp for damage or
overheating.
Is the Fuser Lamp damaged?
2
Replace the Fuser (page 8-11).
Does the problem persist?
3
Replace the Power Supply
(page 8-54).
Does the problem persist?
4
Reseat connections on the Controller
Board.
Does the problem persist?
Wiring and Plug/Jack Map Reference
Map 1 - Controller Board (3140)
Map 2 - Controller Board (3155)
Map 3 - Controller Board (3160B/
3160N)
Yes
Replace the
Fuser Lamp
(page 8-15).
Go to step 3.
Go to step 4.
Replace the
Controller
Board
(page 8-51).
Phaser 3140/3155/3160 Printer Service Manual
No
Go to step 2.
Complete.
Complete.
Complete.