Lag And Lacp Configuration Example - HP procurve 8100fl series Management And Configuration Manual

Link Aggregation Configuration

LAG and LACP Configuration Example

LAG and LACP Configuration Example

Figure 7-1 shows manual LAG11 connecting five ports on System Blue to five
ports on System Red. It also shows LACP 22 connecting three ports on System
Blue to three ports on System Red.
LAG 11
LAG 22
Slot 2
Slot 3
Slot 11 Slot 6
System Red
System Blue
Figure 7-1. Link Aggregation Examples
Configuring A Manual Link Aggregation or LAG. In this example, the
manual aggregator ID is set to 11, which becomes the LAG number assigned
to System Blue's ports 5-7 of the Gigabit Ethernet ports on the interface
module in slot 2, and to ports 5 and 6 on the interface module in slot 11. These
ports connect to System Red's GigabitEthernet ports 5-7 on the interface
module in slot 6, and to ports 5 and 6 on the interface module in slot 3.
Configuring LACP. The LACP aggregator ID is set to 22 and it describes the
aggregation of ports 8-10 on the GigabitEthernet interface module in slot 2 on
System Blue and connected to ports 8-10 on the GigabitEthernet interface
module in slot 3 on System Red.
7-7