Download Print this page

HP FlexFabric 12900 Series Configuration Manual: Configuration Examples; Lacp Mad-enabled Irf Configuration Example For A Two-chassis Irf Fabric

Hide thumbs

Advertisement

Configuration examples

This section provides IRF configuration examples for IRF fabrics that use different MAD mechanisms.
LACP MAD-enabled IRF configuration example for a
two-chassis IRF fabric
Network requirements
As shown in
Configure LACP MAD on the multichassis aggregation to Device C, an HP device that supports extended
LACP.
Figure 12 Network diagram
Configuration procedure
IMPORTANT:
Between two neighboring IRF members, IRF links must be bound to IRF-port 1 on one member and to
IRF-port 2 on the other.
1.
Configure Device A:
# Assign member ID 1 to Device A, and bind Ten-GigabitEthernet 3/0/1 through
Ten-GigabitEthernet 3/0/4 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/3
Figure
12, set up a two-chassis IRF fabric at the access layer of the enterprise network.
32

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: