Creating The Aggregation; Specifying The System; Configuring The Port - HP procurve 8100fl series Management And Configuration Manual

N o t e

Creating the Aggregation

The first thing you must do in creating a dynamic aggregation is to define the
aggregation. Do this by entering from Configuration mode:
ProCurve(config)#aggregator <aggregator ID number>

Specifying the System

1. To specify the system priority value for each host, from Configuration
mode enter:
ProCurve(config)#lacp sys-priority 5
2. Repeat for the partner host.

Configuring the Port

1. To specify the 802.3ad parameters to define the port properties, from
Interface Configuration mode for the port enter:
ProCurve(config-if)#lacp activity
ProCurve(config-if)#lacp aggregation
ProCurve(config-if)#lacp port-key <number>
ProCurve(config-if)#lacp port-priority <number>
ProCurve(config-if)#lacp timeout
ProCurve(config-if)#lacp enable
2. To change the link-assignment algorithm, for instance, to L2 link
aggregation and IP equal-cost multi-path (ECMP) routes, enter:
ProCurve(config-if)#aggr-mode {mac-based | l3-based |
l4-based}
The default link-assignment algorithm is Layer 3-based link assignment
(l3-based).
3. Repeat for each port in the aggregation.
Link Aggregation Configuration
Configuring Dynamic Link Aggregations (LACP)
7-5