N o t e
N o t e
To re-enable flow control:
ProCurve(config)#interface et 1/8
ProCurve(config-if)#flowcontrol
Flow control is enabled by default and is not reported in show interface
configuration displays. The flow control state is only reported when it is
disabled (no flowcontrol).
Assigning a Description
The description line command allows you to enter a text description for a
specified interface.
For example, to label the gigabitethernet port 3 in slot 1 as MAIN TRUNK, enter
the following:
ProCurve(config)#interface gi 1/3
ProCurve(config-if)#description line MAIN TRUNK
To remove this description:
ProCurve(config)#interface gi 1/3
ProCurve(config-if)#no description
You can assign a description to physical ports, virtual routing interfaces and
loopback interfaces.
Configuring Basic System Information and Port Parameters
Configuring Port Parameters
4-13