Displaying SNMP Information
The show snmp command is used to display SNMP configuration information.
The status of the notifications are listed at the bottom of the output.
ProCurve(config)#show snmp
agent operational 343 seconds
In/out packets: 0/0 last:
last error occurred on:
Bad version : 0
Bad community name: 0
Bad community uses: 0
ASN Parse Errors : 0
Too bigs : 0/0
No such name : 0/0
Bad value : 0/0
Read Only : 0
General Error : 0/0
command distribution
Get requests : 0/0 (0.00%)
GetNext requests : 0/0 (0.00%)
Set requests : 0/0 (0.00%)
Get responses : 0/0 (0.00% of in packets)
Variables had/set : 0/0
Silent/Proxy drops : 0/0
Traps sent/received : 2/0 last: Fri Mar 7 00:49:27 2005
ProCurve(config)#
For information on snmp location, contact and host, use the commands that
are shown below:
ProCurve(config)#show snmp location
location: Bunker Hill Lane
ProCurve(config)#
ProCurve(config)#show snmp contact
contact: Umesh
ProCurve(config)#
ProCurve(config)#show snmp host
Address community port
10.200.118.245 private 162
ProCurve(config)#
SNMP Configuration
Configuring Access to MIB Objects
18-9