HP procurve 8100fl series Management And Configuration Manual page 180

IP Routing Configuration
Configuring Basic IP Parameters
ProCurve#show ip route
Codes: R - RIP derived, O - OSPF derived, C - connected,
S - static,
* - candidate default route, IA - OSPF inter area route,
E1 - OSPF external type 1 route, E2 - OSPF external type 2 route,
N1 - OSPF NSSA external type 1 route,
N2 - OSPF NSSA external type 2 route
K
A
Gateway of last resort is 172.17.4.1 to network 0.0.0.0
S 0.0.0.0 [5/0] via 172.17.4.1, 1d20m49s, Mgmt0
4.0.0.0/32 is subnetted, 1 subnets
C 4.4.4.4 is directly connected, Loop0
172.17.0.0/24 is subnetted, 1 subnets
C 172.17.4.0 is directly connected, Mgmt0
172.18.0.0/30 is subnetted, 4 subnets
O 172.18.1.0 [10/3] via 172.18.1.5, 1d19m39s, Gig1/3
C 172.18.1.4 is directly connected, Gig1/3
C 172.18.1.8 is directly connected, Gig1/4
C 172.18.1.12 is directly connected, Lag1000
Number of Routes: 7
11-12
The following example displays the contents of the routing table. It shows that
some of the route entries are for locally connected interfaces ("directly
connected"), while some of the other routes are learned from OSPF.
- Kernel route remnant after rosrd restart
- Aggregate route
[10/3] via 172.18.1.9, 1d19m39s, Gig1/4
To display additional IP information, enter the following commands in
Privileged Exec mode:
Table 11-1. Configuring an Interface for RIP
Command
show ip arp
show ip traffic
show ip ospf
show ip protocols administrative-distance
show ip rxstats <slot>
Action
Show ARP table entries.
Show traffic statistics.
Show OSPF information.
Show IP routing protocol parameters and
statistics
Show Layer 3 receive statistics