Step
6.
Remove the damaged MPU from Switch A,
and insert Switch B's standby MPU into Switch
A.
Displaying and maintaining an IRF fabric
Task
Display information about all IRF
members.
Display the IRF fabric topology.
Display basic IRF settings.
Display the load sharing mode for
IRF links.
Display the master/subordinate
switchover state of IRF members.
Display MAD configuration.
Configuration examples
This section provides IRF configuration examples for two-chassis and four-chassis IRF fabrics that use
different MAD mechanisms.
LACP MAD-enabled IRF configuration example for a
two-chassis IRF fabric
Network requirements
Set up a two-chassis IRF fabric at the access layer of the enterprise network in
MAD in the IRF fabric, because the IRF fabric has a multi-chassis aggregate link to Device C, an HP
device that supports extended LACP.
Command
N/A
Command
display irf [ | { begin | exclude |
include } regular-expression ]
display irf topology [ | { begin |
exclude | include }
regular-expression ]
display irf configuration [ | { begin
| exclude | include }
regular-expression ]
display irf-port load-sharing mode
[ irf-port
[ member-id/port-number ] ] [ |
{ begin | exclude | include }
regular-expression ]
display switchover state [ chassis
chassis-number slot slot-number ]
[ | { begin | exclude | include }
regular-expression ]
display mad [ verbose ] [ | { begin
| exclude | include }
regular-expression ]
32
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Figure
14. Configure LACP