Setting Memory Thresholds - HP procurve 8100fl series Management And Configuration Manual

IP Routing Configuration
Configuring Basic IP Parameters

Setting Memory Thresholds

The routing information base (RIB) is stored in the switch's memory. You can
use the ip table-partition command to configure the percentage of the available
memory that is used for storing IP route entries. (For the command to take
effect, the interface modules in the system need to be rebooted.)
When the threshold level you configure is reached, no new routes are added.
For example, use the ip table-partition command to allocate 80% of the RIB for
IP routes.
ProCurve(config)#ip table-partition percent 80
N o t e
ProCurve recommends table partition settings between 10% and 90%.
11-13