Using Qos Commands; Spolicy Input Commands; Spolicy Output Commands - HP procurve 8100fl series Management And Configuration Manual

QoS Configuration

Using QoS Commands

ProCurve(config-spimap)#map <cos|ip-dscp|ip-precedence> <value>
N o t e
8-4

Using QoS Commands

This section explains the QoS commands available in this release.

Spolicy Input Commands

To access the special policy input mode, enter from Configuration mode:
ProCurve(config)#spolicy-input-map <traffic policy name>
To access the spolicy input mode map command, enter from Policy Map
Configuration mode:
where cos <value> matches the 802.1p Class of Service bits (0-7);
ip-dscp <value> matches the Differentiated Services Code Point bit (0 to 63);
and ip-precedence <value> matches the IP precedence (0-7).
When both cos and ip-dscp are configured, ip-dscp takes higher precedence
and mapping will be done based on ip-dscp.

Spolicy Output Commands

To access the special policy output mode, enter from Configuration mode:
ProCurve(config)#spolicy-output-map <traffic policy name>
The special policy output map mode controls access to four key QoS
commands:
diff-class allows you to specify a diff-serv class and places you in the special
output map differentiated class mode.
diff-group allows you to specify a diff-serv class group and places you in the
special output map differentiated class group mode.
remap allows you to change the cos, ip-dscp, or ip-precedence setting on
various diff-serv classes.