Task
Display IRF configuration.
Display the load sharing mode for
IRF links.
Display MAD configuration.
Configuration examples
This section provides IRF configuration examples for IRF fabrics that use different MAD mechanisms.
LACP MAD-enabled IRF configuration example
Network requirements
As shown in
Configure LACP MAD on the multichassis aggregation to Device E, an HP device that supports extended
LACP.
Figure 14 Network diagram
GE1/0/1~GE1/0/4
GE1/0/2
Device A
XGE1/0/25
XGE1/0/26
(IRF-port1/1)
XGE3/0/25
XGE3/0/26
(IRF-port3/2)
Device C
Figure
14, set up a four-chassis IRF fabric at the access layer of the enterprise network.
Device E
IRF
XGE1/0/27
XGE2/0/27
XGE1/0/28
XGE2/0/28
(IRF-port1/2)
(IRF-port2/1)
GE3/0/2
XGE3/0/27
XGE4/0/27
XGE3/0/28
XGE4/0/28
(IRF-port3/1)
(IRF-port4/2)
Command
display irf configuration
display irf-port load-sharing mode [ irf-port [ member-id/port-number ] ]
display mad [ verbose ]
IP network
GE2/0/1
Device B
XGE2/0/25
XGE2/0/26
(IRF-port2/2)
XGE4/0/25
XGE4/0/26
(IRF-port4/1)
GE4/0/1
Device D
34