Symbols - AEMC 1050 User Manual

2.4 Symbols

MEM/MR: Memory address (1060) - the number is displayed on the small digital
display.
OBJ:TEST: Memory address (1060) - the number is displayed on the small digital
display.
COM: Flashes on the screen when data is transmitted to the serial interface (1060)
or remains permanently displayed if there is a problem during transfer.
DAR/PI: Indicates the mode chosen before insulation measurement or the results
of these measurements.
Dangerous voltage generated; V > 120V.
External voltage present, symbol is activated after pressing START, if
V > 25V
AC
Activation of "time-controlled test" mode or clock adjustment when in SET-
UP (1060).
Indicates that the second function of a button is to be used.
Flashes if the battery voltage is low, indicating that the batteries should
be replaced or recharged (See § 8). The voltage is displayed on the small
display for 2 seconds when the instrument is turned on. The main display
indicates "bat" when the test is carried on.
Signal that lead compensation is in effect.
Warning buzzer is activated.
Indicates that the automatic switch-off function has been deactivated.
SMOOTH: Smooths the insulation measurements displayed.
REMOTE: Remote control via an interface (1060). In this mode, all the buttons
and the rotary switch on the instrument are non-functional, except for the OFF
position.
FUSE HI: Flashes if the "+" input fuse is defective.
FUSE -G-: Flashes if the "G" input fuse is defective.
Shop for AEMC products online at:
12
± 3V or > 35V
DC
www.
.
ShopAEMC
.com 1.877.766.5412
Megohmmeter Models 1050 /1060