Using Dataview; Installing Dataview - AEMC 1050 User Manual

7.1 Installing DataView

DO NOT CONNECT THE INSTRUMENT TO THE PC BEFORE INSTALLING THE
SOFTWARE AND DRIVERS.
Minimum Computer Requirements:
• Windows XP / Windows Vista & Windows 7/8 (32/64 bit)
• 256MB of RAM for Windows XP
1GB of RAM for Windows Vista & Windows 7/8 (32 bit)
2GB or RAM for Windows Vista & Windows 7/8 (64 bit)
• 80MB of hard disk space (200MB recommended)
• USB port
Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
NOTE: When installing, the user must have Administrative access rights
during the installation. The users access rights can be changed after the
installation is complete.
DataView must be reinstalled for each user in a multi-user system.
®
USB Flash Drive Install
1. Insert the USB stick into an available USB port (wait for driver to be installed).
2. If Autorun is enabled then an AutoPlay window should appear as shown.
Shop for AEMC products online at:
42
CHAPTER 7

USING DATAVIEW

®
ShopAEMC
www.
®
.com 1.877.766.5412
Megohmmeter Models 1050 /1060