Table of Contents
Advertisement
Use only factory specified replacement parts. AEMC
for any accident, incident, or malfunction following a repair done other than by its
service center or by an approved repair center.
8.1 Battery Replacement
The battery voltage is displayed on the small digital display for 2 seconds when
switching on the instrument. The main display indicates "bAt".
Before any measurements, make sure that the
a measurement function is selected. If it is displayed, change all the batteries.
NOTE: Make sure that none of the terminals are connected and that the switch
is set to OFF before opening the battery compartment.
Batteries specified: LR14 alkaline (C cell)
1. Unscrew the 4 screws on the underside of the case to open the instrument.
2. Place the instrument on a table and press on the screws to extract the front
panel.
3. Turn the instrument over to remove the front panel unit from the case. The
batteries are then accessible at the back of the panel unit.
4. Unscrew the two screws on the battery compartment.
5. Replace cover before operating the instrument.
NOTE: Make sure that the seal is not damaged during the removal and replace-
ment of the front panel.
8.2 Recharging the Battery
If the
symbol is flashing, then it is necessary to recharge the battery. Con-
nect the instrument to the 120V
automatically:
• bAt on the small display and CHrG on the main display, signifies fast
charging in progress.
• bAt on the small display and CHrG flashing on the main display, signifies slow
Shop for AEMC products online at:
charging (starts off with fast charge, temperature conditions permitting).
52
CHAPTER 8
MAINTENANCE
(Model 1050)
(Model 1060)
power cord via the connector, charging starts
AC
ShopAEMC
www.
will not be held responsible
®
symbol is not displayed when
.com
1.877.766.5412
Megohmmeter Models 1050 /1060
Advertisement
Table of Contents
