2N Helios IP Configuration Manual page 84

Video resolution – set the default image resolution for RTSP streaming.
Video framerate – set the default video frame rate for RTSP streaming.
Video bitrate – set the default video bit rate for RTSP streaming.
Video quality - set the video compression level (for MJPEG only) ranging
between 10 (low quality, lowest bitrate) and 99 (top quality, highest bitrate).
IP address 1–4 – set up to 4 authorised IP addresses from which you can log in
to the RTSP server. If none of the four fields is completed, any IP address can be
used for login.
QoS DSCP value – set the audio/video RTP packet priority in the network. The
set value is sent in the TOS (Type of Service) field in the IP packet header.
UDP unicast enabled – enable audio/video stream sending via the RTP/UDP. If
this mode is off, the audio/video stream data are sent via the RTP/RTSP only.
Maximum video packet size – set the maximum size of the video packets to
be sent via the RTP/UDP.
Tip
®
2N TELEKOMUNIKACE a.s., www.2n.cz
FAQ: VLC Player - How to watch a video from 2N
FAQ: VLC Player - How to record video from 2N
®
Helios IPs RTSP server
®
Helios IP
84