2N Helios IP Configuration Manual page 28

both for user activation and deactivation.
User deactivation code – set a private user deactivation code: up to 16
characters including digits 0-9 only.
User current state – select the current state of the user.
Each user can be assigned a private switch activation code. The user switch codes can
be arbitrarily combined with the universal switch codes defined in the Hardware |
Switches
intercom configuration, the
Code – set a private user switch activation code: up to 16 characters including digits
0–9 only.
Time profile – assign a time profile to the switch code to define the code
validity. If the time profile is inactive, the switch will not be activated by the code
. If multiple time profiles are assigned to a code, the code is valid only if one of
the profiles is active at least.
Each of the intercom users can be assigned one access RFID card. Refer to the Access
Cards
Card ID – set the user access card ID: 6–32 characters including 0–9, A–F. Each
user can be assigned just one access card.
reader, the switch associated with the card reader gets activated. If the double
authentication mode is enabled, the switch can only be activated using both a
card and numeric code.
Time profile – assign a time profile to the user access card to define the card
validity. If the time profile is inactive, the user access card will be detected as
invalid. If multiple time profiles are assigned to a card, the card is valid only if
®
2N TELEKOMUNIKACE a.s., www.2n.cz
menu. If the codes are identical with the codes already defined in the
subsection for details.
mark will appear at the colliding codes.
When a valid card is tapped on the
28