2N Helios IP Configuration Manual page 48

IR LED brightness level - set the infrared LED brightness level in the range
of 0-100% in several steps. Infrared illumination is automatically activated in
night mode. The IR LED brightness level settings are only available in the
2N® Helios IP Verso
Current IR LED brightness level - display the current IR LED brightness level
percentage. The level can
the maximum power consumption cannot be exceeded (typically, when multiple
extenders are connected and PoE supply is used).
Note
Video input – choose one of the analogue camera inputs. You can change the
input by automation via the Action.SetCameraInput during operation.
Video standard – set the video standard for the camera connected. Modify the
value only if the automatic video standard detection does not work well (Auto
value).
Motion detection enabled - enable automatic motion detection via an internal
camera. Motion is detected by monitoring of a brightness change in the selected
image section in time. When objects move within the camera range, the selected
part of the image detects an activity, which can be expressed in percentage. If
the activity exceeds the upper limit, motion is detected and indicated as long as
the activity drops below the lower limit. Select the sensitivity thresholds and
detection area according to the requirements and installation site conditions.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
and
automatically
This setting is only available in the models equipped with an external
analogue camera input.
2N® Helios IP Verso
be decreased below the set value so that
with HD camera models.
48