2N Helios IP Configuration Manual page 38

List of Parameters
Switch enabled – enable/disable the switch globally. When disabled, the switch
cannot be activated by any of the available codes (including user switch codes),
by a call or quick dial button.
Switch mode – set the monostable/bistable mode for the switch. The switch is
switched off after a timeout in the monostable mode, and switched on with the
first activation and off with the next activation in the bistable mode.
Switch-on duration – set the switch-on time for a monostable switch. This
value is not applied in the bistable mode.
Time profile – assign the switch a time profile to enable switch-on. If the time
profile is inactive, the switch cannot be activated by a code, call or quick dial
button.
Distinguish on/off codes - set a switch code mode in which odd codes (1, 3
....) are used for switch activation and even codes (2, 4 ...) are for switch
deactivation. This mode can only be used if the switch is set to the bistable
mode.
Note
Controlled output – assign an electric output to the switch. Choose one of the
available intercom outputs: relay, power output, extender output. If you select
None
equipment via HTTP commands.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Switch time profiles are available with the Gold or Enhanced Integration
licence only.
, the switch will not control any electric output but can control external
38