2N Helios IP Configuration Manual page 40

for example. During an outgoing call the switch is activated after SIP message
180 Ringing is received. The called party confirms ringing by this message. The
switch is active during the whole call in the bistable mode, and activated by the
call beginning and deactivated after the predefined switch-on duration in the
monostable mode.
Activation by quick dial button – assign a quick dial button to the switch. The
switch is activated whenever the button is pressed.
Sound signalling – set the sound signalling type for switch activation. Choose
the Short beep, Long beep (during the whole activation) or a User sound (refer to
the User Sounds subsection).
Display info – enable/disable signalling of an activated switch on the display.
Synchronise with – set switch synchronisation to enable automatic switch
activation after another switch activation with a predefined delay. Define the
delay in the
Synchronisation delay – set the time interval between synchronised activations
of two switches. The parameter will not be applied if the
disabled.
Note
Command sent upon activation – set the command to be sent to the external
device (WEB relay, e.g.) upon switch activation. The command is sent via the
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Synchronisation delay
The HTTP command sending is available with the Gold or Enhanced
Integration licence only .
parameter
Synchronise function is
40