2N Helios IP Configuration Manual page 110

5.5.1 Network
As the
has been set correctly or obtained from the LAN DHCP server. Configure the IP address
and DHCP in the
Tip
If you use the RADIUS server and 802.1x-based verification of connected equipment,
you can make the intercom use the EAP-MD5 or EAP-TLS authentication. Set this
function in the
The Trace
intercom network interface. The file with captured packets can be downloaded for
Wireshark processing, e.g.
List of Parameters
Network
Use DHCP server – enable automatic obtaining of the IP address from the LAN
DHCP server. If the DHCP server is unavailable or inaccessible in your LAN, use
the manual network settings.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Helios IP intercom is connected to the LAN, make sure that its IP address
Network subsection.
To know the current IP address of your intercom, use the 2N
Scanner , which can be freely downloaded from
steps described in the Installation Manual of the respective intercom: the
intercom communicates its IP address to you via a voice function.
802.1x tab.
tab helps you launch capture of incoming and outgoing packets on the
(www.wireshark.org).
®
Helios IP
www.2n.cz , or apply the
110